Description
Description
This is a starter kit point for those eager to learn Arduino programming and basic electronics, integrated with design-driven robots! This kit comes with a lot of SnappyXO hardware parts, an Arduino, an ultrasonic sensor, IR sensor, remote, limit switches, and many other useful electronics components. You can also use our apps and curriculum to learn robot motion design and programming.
Additional information:
| Weight | 4 lb |
|---|---|
| Dimensions | 12 × 9 × 6 in (Two Boxes) |
Contents – Hardware Parts
- 3X channel plates x3
- 4X channel plate x1
- 2X beams x6
- 3X beams x6
- 4X beams x4
- 5X beams x4
- 6X beams x4
- 7X beams x2
- 8X beams x2
- Outer wheels x4
- Inner wheels x2
- Gears x2
- Pinions x2
- Motor Pinions x2
- Launcher x1
- Gear adapters x2
- L clips x15
- C Clips x10
- H clips x15
- Wheel H clips x4
- Sliding C clips x4
- 60 degree clips x6
- 45 degree clips x6
- Fixed pivots 1F x8
- Fixed pivots 2F x2
- Fixed pivots 3F x4
- Moving pivots 1M x6
- Moving pivots 2M x2
- Wire holder clips x2
- DC motor Flange x4
- Small Static Caster x1
- Big Static Caster x1
- Dynamic Caster 1X x1
- Dynamic Caster 2X x1
- Dynamic Caster Holder x1
- Arduino Mount x1
- Servo Mounts x3
- Servo Horn 2X x3
- Servo Horn 1X x3
- Limit switch mount x2
- Ultrasonic sensor mount x1
- 25 pt. breadboard mount x1
- 400 pt. breadboard mount x2
- DC motor mount and support set x2
- 9V battery mount x2
- 6V battery mount x2
- Spacers x15
- Delrin rods (1 inch) x6
- Delrin rods (2.5 inch) x4
- Delrin rods (5 inch) x2
- Delrin Rod Flange (Press Fit) x2
- Rubber O rings (Tires) x2
- Rubber Bands x2
- Steel Ball x1
- Ping-Pong Ball x1
Contents – Mechatronics Parts
- Arduino compatible Uno board – 1
- DC Gearhead Motors – 2
- Continuous Rotation Servos – 2
- Finite Rotation Servo – 1
- Remote Control Module – 1
- Ultrasonic Sensor – 1
- Limit Switches – 2
- 400 pt. breadboard – 1
- 25 pt. breadboard – 1
- H-bridge L293D IC – 2
- Photocells – 2
- Buzzer – 1
- Momentary Switches (4 legged) – 2
- Momentary Switches (2 legged) – 2
- Breadboard Slide Switch – 1
- 10k Potentiometer – 1
- 9V Battery Snap (Plug type) – 1
- 9V Battery Snap (I-type) – 1
- AA battery holder (6V) – 1
- 140 Pieces Wire kit – 1
- M-M, M-F, F-F wires – 20 each
- Resistors 330Ω, 1kΩ, 10kΩ – 5 each
- Red, Blue and Green LEDs – 5 each
- Multicolor LED – 1
- 9V Battery – 1
- AA Batteries – 4
- DC Motor Wheels – 2
Reviews
There are no reviews yet.